[fluxx] Blanxx and Rubber stamps

[TheLoneGoldfish]

I think sharpies would dry far too quickly for that. It's just a shame about
not being able to stamp... unless I was to use paint or something. The
problem I see is that anything that would melt a plastic coating on a card
would probably not be good for rubber.

I'm going to let this batch of tests sit a while longer (until this evening)
to see if the pens settle better. The permanent nature of the ink is
probably a problem in this case as they're designed to be non-reactive
acid-free etc so they probably cannot dissolve the coating. I still have
hopes though that perhaps the face side of the cards are better for writing
than the "back" side (I don't know actually which I tested on earlier)

-Evan

On 10/19/06, david <david at dasnet.org> wrote:
>
> > Sharpies work well because the solvent in them dissolves the plastic
> > a little so that the ink bonds to the card coating when it dries. One
> > down side of this is that a little bit of plastic gets sucked into
> > the tip of the marker.
>
> I wonder, could you use a sharpie to quickly "paint" the raised surface of
> a rubber stamp, then stamp it on?
>
>
> david.
> (or, could you use a very thin but strong plastic tape to protect what's
> been drawn on?)
>
>
> _______________________________________________
> Fluxx mailing list
> Fluxx at lists.looneylabs.com
> http://lists.looneylabs.com/mailman/listinfo/fluxx
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.looneylabs.com/pipermail/fluxx/attachments/20061019/3978f3f5/attachment.htm